Catalystスイッチで、インターフェイスのステータスにNot Presentが表示される

この「Not Present」のステータスは何か、というと SPFが入っていないか、壊れているか、そのときに表示される。

SFPポートとRJ45のポートがスイッチするようなポートであれば、 RJ45がリンクアップしているとリンクアップの表示になる。

「show interface status」をすると、下記のようになる

Gi0/21                       notconnect   106          auto   auto Not Present

下記は、show interfaceしたところ。

GigabitEthernet0/21 is down, line protocol is down (notconnect)
  Hardware is Gigabit Ethernet, address is 0019.e854.d095 (bia 0019.e854.d095)
  MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive not set
  Auto-duplex, Auto-speed, link type is auto, media type is Not Present
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 multicast)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out
スポンサーリンク

シェアする

  • このエントリーをはてなブックマークに追加

フォローする